HOW TO ASSEMBLE CPU

 STEP 1 : Prepare the Motherboard

 Support Component of Motherboard :

1. SATA Cable
2. IDE Cable
3. HSF (Heat Sink & Fan)
4. Connector Power SATA
5. Processor
6. CD Driver
7. Ram
8. Hard disk
9. VGA Card

STEP 2 : Add Processor

• Open Socket on motherboard.

• Open padlock on motherboard.

• Take and grab the processor like a picture 1, don’t touch pin on processor.

• Don’t press it, just place with carefully and lock it again.

• Now, we add the Heat Sink & Fan by the footpin stand into hole on motherboard (picture 2)

• Set the power connector Fan on motherboard (picture 3).

STEP 3 : Add Memory (RAM)

• On the motherboard,  open two padlock of slot memory.

• Don’t press it, just place with carefully.

• Press corner of memory together until you hear “klik” that the memory on the good position.

STEP 4 : Prepare and set the motherboard on casing

• Add plate motherboard on back of casing.

•Add bolt adjust the motherboard.

• Add bolt holder (spacer) adjust the motherboard.

• If the casing ready, set the motherboard into casing, be careful and adjust the bolt.

• Tighten the bolts covered as possible.

STEP 5 : Add Hard Disk

• Plug the hard disk to casing and tighten with bolts.

• Connect the hard disk connector to power supply connector.

• Make sure the connector are properly connected

•Plug the power connector to hard disk.

•Plug the power connector to port power connector.

•Plug the SATA connector to port SATA on motherboard.

• Then also plug the SATA connector to port on hard disk

• Make sure all off connector are properly connected.

STEP 6 : Add VGA Card and power cable

•Remove the plate cover on back casing.

• Plug the VGA to PCI slot on motherboard.

• Press it until plug as good

• Tighten with bolt if you need to tight it.

• Plug the power supply connector to slot on motherboard.

• Press it and make sure it properly connected.

• Plug the 4 pin power connector to motherboard

• Plug 24 Volt connector from power supply to motherboard.

• Press it and make sure as properly connected

STEP 7 : Plug the Front Panel

• Watch the cable, don’t plug the connector wrong

• Plug the connector to pin 1 and 3 on motherboard

• The cable of power button on casing, plug it to pin 5 and 7 on motherboard

• The cable of reset button on casing, plug it to pin 6 and 8 on motherboard.

• The cable of front USB on casing, plug it to USB slot on motherboard.

• The cable of front audio on casing,  plug it to pin audio on motherboard.

• If you hard to find all of them, you should read and find it on the manual book.

STEP 8 : Close the casing

•Before you close the casing, make sure all component are properly connected.

• Take the last cover of casing and put it to close casing.

• Tighten the cover by bolts.

STEP 9 : PLUG THE HARDWARE CONNECTOR

·         Plug the power supply connector to CPU

·         Plug the keyboard cable connector

·         Plug the mouse cable connector

·         Plug the cable audio to CPU as a color 

·         Plug the cable USB to CPU ( if be required)

·         Plug the monitor cable to CPU

THE COMPUTER IS READY TO START